*Biorb & Biube Service Kit (Multi Pack)

BiOrb Service Kit - MULTI PACK

Buy 3 Service Kits and save!

The Biorb and Biube service kit is a must have for anyone who has just purchased a Reef One tank. The BiOrb Service Kit contains a replacement filter cartridge, the filter cartridge works like a waste bin, trapping dirt, once full it should be thrown away and replaced with a new one. Biorb Filter cartridges need replacing every 1-2 months depending on how many fish you have in your Reef One Tank. The service kit also contains an algae removing cleaning cloth, used to wipe the algae of the inside of your Biorb or Biube without scratching the bowl. Lastly the kit contains sachets of water preparation, and algae prevention sachets. Once you have had your Biorb or Biube for over a month, its time to turn to the service kit! The kit is a must have for keeping a Biorb tank clean and healthy.

Contents :

FOR THE BEST RESULTS FOLLOW THESE SIMPLE 8 STEPS.

Ideally perform steps 1 and 2 24 hours before starting step 3. The fresh water will need at least 1 hour to stabilize and reach room temperature.

STEP ONE: Wipe the inside of the biOrb to remove any algae growth that may have occurred. Use the rough side for stubborn marks only.

STEP TWO: Mix the chemical from the sachet of Water Treatment into 10 litres of tap water. Allow water to stabilize for at least 1 hour, preferably 24 hours.

STEP THREE: Turn off air pump. Gently twist in direction of arrow and lift away filter from fixed base unit of biOrb.

STEP FOUR: Siphon 1/3rd of the water from the biOrb. Agitating the rocks will help loosen any trapped dirt. Place siphon tube into filter recess and suck through the holes. Removing the solid waste will help prevent nitrate and phosphate build up.

STEP FIVE: Gently twist in direction of arrow and lift away bubble tube from old filter cartridge.

STEP SIX: Offer up new filter cartridge to bubble tube and twist in direction of arrow ensuring all four cartridge tabs are fully locked.

STEP SEVEN: Making sure there are no fish in the way, secure new filter cartridge back into base unit.

STEP EIGHT: Slowly top up with the water prepared in step 2. Turn on air pump. Allow water to stabilize for 1 hour then add chemicals from Stress Zyme sachet.